Water Resistant Case
PDA holder for motorcycles. 31,8 mm diameter.
When the PDA is in the case, it is well protected from rain and dust. You can take the case with the PDA with you when leaving the motorcycle. It is easy to put the PDA in the case, and to take it out of the case. You can have a charging- or GPS-cable as well as a headset connected to the PDA when it is in the case. The case is attached onto a tilt swivel, so you can adjust your PDA for easier viewing.
The installation of the water resistant case is quick and easy. The water resistant case has a protective hard shell with a soft transparent front. (Not water proof, do not put in water)
Fits units smaller than 85x152x28,5 mm.
Item no 215345
EAN: 7320282153458
1.
2.
3.
4.
Please read all of the instructions and look at the pictures before the installation.
1. In the box, there are a number of soft plates of various thickness. Adjust the number of plates to suit the thickness of our PDA. The PDA is to be gently fixed into place, not loose and moving, inside the box. You should be able to close the box without exposing the PDA for heavy pressure.
2. It is important that the cable is properly in place in the box, nox exposed for heavy pressure. Adjust the soft plates so the height is good. Put the cable in the groove in the bottom of the box (only the cable is to be in the groove, not parts of the connector or the connector housing). The other groove in the bottom of the box can be used e.g. for a headset.
3. Put the PDA in the box. Close the lid of the box and in the same time make sure that the cables are properly in place. Close the box and secure the clips on the side of the box.
4. The PDA is in the box.
The message has been sent
Could not send the message
