1.

3.

Please read all of the instructions and look at the pictures before attaching the holder.  
 
1. Attaching the holder: Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.  
 
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.  
 
3. Placing the device in the holder: Place the device next to the holder and slide it carefully sideways into the holder. Slide the device into the holder so you hear/feel it snaps into place.  
 
4. The holder is in place, with a device in place. Switch easily between an upright, closed position and a horizontal, open position by turning the holder.