Please read all of the instructions and look at the pictures before attaching the holder.
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.
2. To place the device in the holder: Place the lower part of the device in the holder. Flip/press the upper part forward so it snaps into place in the holder. Carefully, slide the device rightwards into the holder so you hear/feel it snaps into place when it connects to the connector.
3. To remove the device from the holder: Slide the device leftwards, away from the connector. Press upward on the upper part of the holder. In the same time: pull the upper part of the device toward you and lift the device up and out from the holder.
4. The holder is in place.