ProClip
Item no 854762 - Angled mount
EAN: 7320288547626
Item no 854762 fits:
- Freightliner Cascadia 08-12 (For USA)
1.
2.
3.
4.
Please read all of the instructions and look at the pcitures before attaching the ProClip. This ProClip consists of two parts: Part 1: The small block with curved lip. Part 2: The ProClip faceplate
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Loosen (do not remove) the two right side torx screws on the control panel. Press the thin end of the enclosed gap opener into the gap in the center console sidewall, to widen the gap. Start at the far right side of the gap and slide it leftward into the correct position.
2. Peel off the cover of adhesive tape on both parts. Insert the curved edge of Part 1 into the gap next to the gap opener. Flip/rotate Part 1 upward so the curved edge goes into the gap. Before adhering it to the dash please make sure the holes will line up with Part 2.
3. Pull the panel towards you in order to widen the gap. Press the curved edge of Part 2 into the panel gap. Flip/rotate the right side of the ProClip toward Part 1. Match the holes on the right side of Part 2 with the holes on Part 1 using the lines on top of Part 1 for guidance. Use the enclosed screws to attach Part 2 to Part 1. Draw the screws tight but be careful not to over tighten. Tighten the 2 torx screws in the control panel.
4. The ProClip is in place.
Attach a holder onto your ProClip!
You need two parts; a ProClip for your car, and a holder for your device. Find the correct holder for your device here:
The message has been sent
Could not send the message
