Log in...

Passive holder with tilt swivel

This mount offers an easy and secure way to mount your printer. Combining functionality and convenience, Brodit products contribute to an improved working environment. Custom made mount with a perfect, firm fit. Attach onto a Pedestal Mount or a high strength ProClip mounting platform.


The holder is equipped with a tilt swivel so you can easily adjust the angle. Tilts 17° and swivels 360°. With AMPS-holes. Made of high grade ABS/Acetal plastic. Color: black. Made in Sweden.

  • Item no: 216132
  • EAN: 7320282161323

  • Width: 66 mm
  • Height: 133 mm
  • Depth: 40 mm
  • Volume: 351 cm³
  • Weight: 84 g

Item no 216132 fits:

  • Zebra ZQ320 (For all countries)





Please read all of the instructions and  look at the pictures before attaching the holder.
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
2.  Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw so the holder is firmly in place, but still can be adjusted.
3. To place the device in the holder: Place the lower part of the device in the lower part of the holder. Press/flip the upper part of the device downard into the holder.
To remove the device from the holder: Press the upper part of the holder upward. Pull the upper part of the device away from the holder. Lift the device up out from the holder.
4. The holder is in place.

Attach your holder onto a ProClip!

You need two parts; a ProClip for your car, and a holder for your device. Find the correct ProClip for your vehicle here: