Log in...

Mount

Rail mount for OtterBox uniVERSE phone cases. With tilt swivel. (May block the camera on some devices.)  

Keep your phone installed while driving and you will always have it within easy sight and reach! Rail mount for use with any OtterBox uniVERSE phone case. Simply snap/slide your phone into place on the rail mount with a one-hand grip. For easy attachment with a perfect, firm fit. Neat, discreet and convenient.

 

 This mount may block the camera on some devices.

 

The mount is equipped with a tilt swivel so you can easily adjust the angle for better viewing, or switch easily between portrait and landscape mode. Tilts 17° and swivels 360°. Mounting plate 42x50 mm with 4 mm AMPS-holes. Made of high grade black ABS/Acetal plastic. Made in Sweden. Attach onto a ProClip mounting platform or Pedestal mount.

 

  • Item no: 241631
  • EAN: 7320282416317

  • Width: 53 mm
  • Height: 118 mm
  • Depth: 33 mm
  • Volume: 206 cm³
  • Weight: 73 g

INSTALLATION INSTRUCTIONS:

1.

2.

3.

4.

Please read all of the instructions and look at the pictures before attaching the mount.  
   
1. Loosen the screw in the center of the mount so you can remove the tilt swivel attaching plate on the back.  
   
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the mount over the attaching plate so the screw fits in the hole in the center. Tighten the screw until the mount is firmly in place, but still can be adjusted.     
   
3. To mount your device with uniVERSE case: Remove the rail plate from your OtterBox uniVERSE case. Place the device above the mount and slide it downward onto the rail mount until it clicks into place.  
To remove the device with uniVERSE case: Slide the device upward and out from the mount.  
   
4. The mount is in place.