Log in...

Holder with locking bracket

With straight cable for fixed installation. 12/24 Volt, 2 A charger. With Torx key.

A holder for fixed installation of your device. The choice for you who want to have your device permanently installed in the vehicle. The device is locked into the holder so it can not be removed easily. Active holder for fixed installation. Gives a neat installation without loose cables. Install over a 2 A fuse inside the dashboard. Professional installation recommended. 12/24 Volt. Fits devices with a TMC module. (TMC module not included).  A Torx-key that is needed for the installation is included. (Can also be orderd without the Torx-key, item no 276013.)


The holder is equipped with a tilt swivel so it can be adjusted in order to avoid light reflection on the screen. Attach onto ProClip Mounting Platform.

  • Item no: 276016
  • EAN: 7320282760168

Item no 276016 fits:

  • TomTom GO 520 T (For all countries)
  • TomTom GO 720 T (For all countries)
  • TomTom GO 920 T (For all countries)





Please read all of the instructions and look at the pictures before attaching the holder.  
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate on desired position. Screw the attaching plate into place with the enclosed screws.  
2. Place the holder over the attaching plate so the tilt swivel fits. Screw the holder onto the attaching plate. Place the TMC cable behind the front part of the holder. Press the connector into the groove in the holder. Press it all the way into the groove so it is properly in place.  
3. Place the device in the holder. Place the enclosed angle behind the holder so the holes fit. Screw the angle into place with the enclosed screws, so the device is locked into place.  
4. The holder is in place.