Log in...

Passive holder

Extra strength holder.

This holder is the perfect choice when you want to have your device firmly in place within easy reach. Custom fit for bare devices (NOT for use with expansion module/handstrap/rugged frame). The holder is made of extra strong plastic. Attach the holder to any flat surface or a Pedestal Mount in a truck, distribution vehicle, warehouse etc. Predrilled AMPS and VESA standard holes. You have full access to the camera and all buttons and outlets when the device is in the holder.

 

Made in Sweden. Made of high grade ABS and Acetal plastic. Color: Black. Devices should not be installed onto a vehicle's dashboard if blocking the view or key controls. An installation of a device in a vehicle is always done on the customer's own responsibility.

 

Dimensions: 288 x 198 x 36 mm (W x H x D mm)

Weight: 420 g

  • Item no: 510883
  • EAN: 7320285108837

Item no 510883 fits:

  • Zebra ET50 10.1 (For all countries)
  • Zebra ET51 10.1 (For all countries)
  • Zebra ET55 10.1 (For all countries)
  • Zebra ET56 10.1 (For all countries)
INSTALLATION INSTRUCTIONS:

1.

2.

3.

4.

Please read all of the instructions and  look at the pictures before attaching the holder.  
   
1. Place the holder onto the desired position and screw into place with the enclosed screws.  
   
2. To place the device in the holder: Place the lower part of the device in the holder, then flip/press the upper part forward so it snaps into place in the holder.  
   
3. To remove the device from the holder: Press upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.  
   
4. The holder is in place.

Related Products