Log in...

Passive holder with tilt swivel

For a more secure upright and horizontal position. Padded.

This is the choice for you who are using your iPhone with navigation and easily want to switch between an upright position and a horizontal position - simply turn the holder into desired position. When installing, place the holder in the desired position (upright/horizontal) that you will be using as standard. The holder provides a more secure upright and horizontal position than a standard holder.


When keeping your iPhone in a passive holder, it is always within easy sight and reach. A portable handsfree or a charging cable can be connected to the device when it is in the holder. You can attach the cable to the holder, it will then be easy accessable whenever you want to use it. (Cable not included)


The passive holder is attached to a tilt swivel, this means you can adjust the angle of the device in order to avoid light reflection on the screen. Attach onto ProClip Mounting Platform.

  • Item no: 511041
  • EAN: 7320285110410

Product sheets: 233312.pdf

Item no 511041 fits:

  • Apple iPhone 3G (For all countries)
  • Apple iPhone 3GS (For all countries)





Please read all of the instructions and look at the pictures before attaching the holder. The holder in the installation pictures may look slightly different from the one you have received. However, the same instructions apply.  
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted. You can easily switch between an upright and a horizontal position, simply by turning the holder into desired position.  
2. To place the device in the holder: Place the bottom part of the device into the holder. Press the top of the device forward and in the same time slide the device downward into place in the holder. To remove the device from the holder: Press the upper part of the holder forward. When the device is set free, lift it upward out of the holder.  
3. If you are using a cable to your device: Press the cable into place in the cable holder in the bottom part of the holder. The cable will then be held in place giving a neat installation.  
4. The holder is in place.

Related Products

Attach your holder onto a ProClip!

You need two parts; a ProClip for your car, and a holder for your device. Find the correct ProClip for your vehicle here: