Log in...

Active holder for fixed installation

With tilt swivel, with Molex adapter system. 2A charger.

Robust active holder with rugged design to withstand rough handling in professional everyday use. Keeps your device extra securely in place in the holder. Thanks to the swiveling top part which ”locks” the device in the holder, the charging is properly connected at all times and the device can not shake the least. Custom made with a perfect fit.

 

An active holder which is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior. You can choose to use the holder as an active holder for charging of your device only, or to connect an adapter to the Molex connector for additional features. Then you can use the holder also for power supply of your own solutions (can not be used for data communication or audio connection).

 

The product is E-approved. Connect the power cable with a 2 A fuse. Professional installation recommended. The holder is equipped with a tilt swivel so you can easily adjust the angle for good viewing. Tilts 15°, swivels 360°. Attach onto a Pedestal Mount or High Strength ProClip Mounting Platform. Made of black Acetal/ABS plastic. Made in Sweden

 

Dimensions: 78 x 90 x 73 mm (W x H x D mm)

Weight: 197 g

Cable length: Total length: 241 cm (Holder to box: 70 cm, Connectors+box 14 cm, Box to open end: 157 cm.)

 

Charging specifications:

Input voltage: DC/10-24V

Charging voltage: DC/4.6-5.3V

Output current(Typ): 3.0A

Input & output protection: Input polarity reversal/Output over voltage/Output over current/Output short protection

LED charging indicator: Product output indicator

Operating temperature: 0°C ~ +40°C

Storage temperature: -20°C ~ +80°C

RoHS compliant: ROHS

  • Item no: 513930
  • EAN: 7320285139305

Item no 513930 fits:

  • myPOS D200C (For all countries)
INSTALLATION INSTRUCTIONS:

1.

2.

3.

4.

Please read all of the instructions and look at the pictures before attaching the holder.  
   
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.  
   
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.  
   
3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.  
   
4. The holder is in place.

Related Products

Attach your holder onto a ProClip!

You need two parts; a ProClip for your car, and a holder for your device. Find the correct ProClip for your vehicle here: