Log in...

Holder with Pass-Through Connector

For a more secure upright and horizontal position. Adjustable holder, fits devices with skins.

Fits for all cables! A holder that provides a neat, firm installation for many areas of use. All cables that can be used with the iPhone can also be used with the holder, for example a charging cable or an interface cable. When you have attached the cable to the holder it is firmly in place and you do not have connect it manually to the iPhone each time you put it in the holder. You can run the cable through the back part of the holder for an even cleaner look. (Cable not included)


The choice for you who are using your iPhone with navigation and easily want to switch between an upright position and a horizontal position; simply turn the holder into desired position! The holder provides a more secure upright and horizontal position than a standard holder. Safe, comfortable and convenient! The holder has a neat and discreet design which blends well with the vehicle's interior. When keeping your iPhone in a passive holder, it is always within easy sight and reach.


The holder is made of ABS plastic and is padded. This means it has a plush coating which is extra protective for your device. The holder has a perfect fit. It is easy to put the device into the holder, and just as easy to take it with you when leaving the vehicle.  The holder fits for iPhone with skin or with Apple original Bumper (does NOT fit for iPhone without skin).


The holder is equipped with a tilt swivel so you can adjust the angle of your device in order to avoid light reflection on the screen. You can tilt the holder 22° in each direction. Attach onto ProClip Mounting Platform.

  • Item no: 516193
  • EAN: 7320285161931

Item no 516193 fits:

  • Apple iPhone 4 (For all countries)
  • Apple iPhone 4S (For all countries)





Please read all of the instructions and look at the pictures before attaching the holder.  
1. To adjust the holder to your unit: Loosen the screws on the back side of the holder, so the sides of the holders can be adjusted. Place the unit in the holder and press the sides together so the unit is firmly in place. Screw on the screws on the back side of the holder.  
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.  
3. To place the device in the holder: Place the bottom part of the device into the holder. Press the top of the device forward and in the same time slide the device downward into place in the holder.To remove the device from the holder: Press the upper part of the holder forward. When the device is set free, lift it upward out of the holder.If you are using a cable to your device: Press the cable into place in the cable holder in the bottom part of the holder. The cable will then be held in place giving a neat installation.  
4. The holder is in place.

Related Products