Log in...

Active holder with cig-plug

Fits for devices with original skin. With USB-cable with cig-plug adapter. With tilt swivel.

Active holder with a USB-cable with cig-plug adapter for charging of your device. You can choose to connect the cig-plug to the car's 12 Volt socket, or to remove the cig-plug adapter and connect the USB cable to the car's (or stereo's) USB connector. Equipped with a tilt swivel so you can adjust the angle and easily switch between portrait and landscape mode. 12V.

 

Tablets should not be installed onto a car’s dashboard if they block the view or block key controls. The ProClip is designed for installation of smaller devices e.g. smartphones, not large tablets. If you want to place a tablet onto the car’s dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations.

 

An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit recommends to use tablets on the car’s headrest, installed onto a Brodit headrest mount.

 

Important note!

In order to be able to transmit audio files from your device through the USB-cable, this feature must be supported by the stereo in your car. You can easily test if this works by connecting your device to the stereo with the USB/charging cable that comes with your device. Charging through USB works regardless.

 

This product supports Qualcomm QC 2.0 quick charge (provided the device supports Qualcomm QC 2.0 quick charge).

  • Item no: 521676
  • EAN: 7320285216761

Item no 521676 fits:

  • Samsung Galaxy Tab Active 8.0 SM-T365 (For all countries)
INSTALLATION INSTRUCTIONS:

1.

2.

3.

4.

Please read all of the instructions and  look at the pictures before attaching the holder.  
   
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.  
   
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.  
   
3. To place the device in the holder: Hold the device in an angled position, screen facing downwards. Place the lower part of the device into the holder where the opening between the sidewalls is widest. Flip the upper part of the device forward so the device goes flat into the holder. Slide the device straight downward into the holder.  
To remove the device from the holder: Press the device straight upward so the lower part reaches the widest part of the opening between the sidewalls. Flip the upper part of the device away from the holder and lift the device out from the holder.  
   
4. The holder is in place.

Related Products

Attach your holder onto a ProClip!

You need two parts; a ProClip for your car, and a holder for your device. Find the correct ProClip for your vehicle here: