Log in...

Active holder for fixed installation

Slim design with charger integrated in the holder.

The cables are to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior. The charging device is integrated in the holder itself, so there is no large charging box on the cable.

 

12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation recommended.

 

The holder fits devices both with standard and extended battery. Attach onto ProClip Mounting Platform.

  • Item no: 532160
  • EAN: 7320285321601

Item no 532160 fits:

  • Hypercom M4100 (For all countries)
INSTALLATION INSTRUCTIONS:

1.

2.

3.

4.

Please read all of the instructions and look at the pictures before attaching the holder. Important Note: Route the cable from the holder into the vehicle dashboard and route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle.  
 
1. Remove the attaching plate on the back.  
 
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder on the attaching plate by pushing it on from above.  
 
3. To place the device in the holder: Place the bottom part of the device into the holder. Push the device forward into place in the holder. To remove the device fron the holder: Open the latch on the holder. Then the device is set frre, lift it towards you out of the holder.  
 
4. The holder is in place.

Attach your holder onto a ProClip!

You need two parts; a ProClip for your car, and a holder for your device. Find the correct ProClip for your vehicle here: