Active holder for fixed installation
Slim design with charger integrated in the holder.
Are you using a two-way radio every day in your work? Then a Brodit active holder will make your days much easier! By keeping the device in an active holder, you will always have it within easy sight and reach while driving between jobs. The cables are to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior.
The charging device is integrated in the holder itself, so there is no large charging box on the cable and LED indicator to show that charging is in progress, the indicator changes from red to green when fully charged. 12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Professional installation recommended. Attach onto ProClip Mounting Platform.
- Item no: 532360
- EAN: 7320285323605
Item no 532360 fits:
- Kenwood NX-300 (For all countries)
- Kenwood TK-3180 (For all countries)
- Kenwood TK-5310 (For all countries)
Charging Specifications:
Battery Chemistry: NiCd and NiMH batteries and Li-ion and Li-Poly batteries
Input Voltage: 11-30 V
Output Voltage: NiCd+NiMH: 7.5 V, Li-ion+Li-Poly: 8.4 V
Timer for Max. Charging Time: NiCd+NiMH: Yes, Li-ion+Li-Poly: Automatic, stops at 8.4 V
Max. Charging Time: 2-3 hours depending on battery capacity
Rapid Charge: 1A +/- 5%
Trickle Charge: NiCd+NiMH: 4 mA, 0 to 50 mA
LED Charging Indicator: LED Red to Green indicator
Temperature Control: NiCd+NiMH: NTC-resistor in battery required, Li-ion+Li-Poly: Controlled by battery
Operating Temperature: -40° C to + 50° C / -40° F to 122° F (can be restricted by battery chemistry)
RoHS Compliant: Yes
Input Transient Protected:Withstands +150V & -450V. A 2,5A fuse is mounted on the incoming supply.
Output Short Circuit Protected: The charger will supply a maximum current of 1 A which protects both the charger and the connected equipment. The current limit is set to standards of the producer and shall not be higher.
Attach your holder onto a ProClip!
You need two parts; a ProClip for your car, and a holder for your device. Find the correct ProClip for your vehicle here: