Log in...

Holder with lock.

Active holder with cig-plug and USB cable. With tilt swivel. 2 keys included.

This holder is to be used when you will secure your iPad Air and still have it easy accessable. Perfect for use in stores, at exhibitions and any place where you want to use your iPad without having it easy removable. In order to remove the unit  from the holder you need the key or a certain amount of violence is required. The holder includes a lock and two keys.

 

The active holder charges your battery when it is in the holder. The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection. Connects to the vehicle’s cigarette lighter socket, 12/24 Volt.

 

Length of charging cable: 123 cm.

 

Tablets (Surfpads) should not be installed onto a car’s dashboard if they block the view or block key controls. ProClip (Brodit’s vehicle mounting bracket) is designed for installation of smaller devices like mobile phones and GPS devices, ProClip is not designed for large devices like tablets. In some vehicles the ProClip has an extra firm fit and can then be used also for installation of a tablet. If you want to place a tablet onto the car’s dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations.

 

An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit recommends to use tablets on the car’s headrest, installed onto a Brodit headrest mount.

  • Item no: 535577
  • EAN: 7320285355774

Item no 535577 fits:

  • Apple iPad 5th Gen (A1822, A1823) (For all countries)
  • Apple iPad 9.7 6th Gen (A1893, A1954) (For all countries)
  • Apple iPad 9.7 New (For all countries)
  • Apple iPad Air (A1474, A1475, A1476) (For all countries)
INSTALLATION INSTRUCTIONS:

1.

2.

3.

4.

Please read all of the instructions and look at the pictures before attaching the holder.  
 
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw the holder onto the attaching plate. Tighten the screw so the holder is firmly in place, but still can be adjusted.  
 
2. Slide the device sideways carefully into the holder. Press the lock sideways onto the left part of the holder. Press the button to lock.  
 
3. Use the enclosed key to open the lock. Remove the lock by slidning it sideways away from the holder. Slide the device sideways carefully out of the holder.  
 
4. The holder is in place. Switch between portrait and landscape mode by turning the holder into desired position.

Related Products