Log in...

Holder for Locking

Passiv holder with tilt swivel. Fits for devices with original skin. With spring stud locking.  

The holder with locking is to be used when you want to have your tablet extra firmly in place. The holder has a spring stud locking device, it keeps your device in a firm grip in the holder. You can connect e.g. a charging cable to the device when it is in the holder.

 

The holder is mounted onto a tilt swivel. This mean you can easily adjust the angle for better viewing and switch between portrait and landscape mode simply by turning the holder into desired position.

 

Tablets (Surfpads) should not be installed onto a car’s dashboard if they block the view or block key controls. ProClip (Brodit’s vehicle mounting bracket) is designed for installation of smaller devices like mobile phones and GPS devices, ProClip is not designed for large devices like tablets. In some vehicles the ProClip has an extra firm fit and can then be used also for installation of a tablet. If you want to place a tablet onto the car’s dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations.

 

An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit recommends to use tablets on the car’s headrest, installed onto a Brodit headrest mount.

  • Item no: 541676
  • EAN: 7320285416765

Item no 541676 fits:

  • Samsung Galaxy Tab Active 8.0 SM-T365 (For all countries)
INSTALLATION INSTRUCTIONS:

1.

2.

3.

4.

Please read all of the instructions and  look at the pictures before attaching the holder.  
   
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.  
   
2. To place the device in the holder: Hold the device in an angled position, screen facing downwards. Place the lower part of the device into the holder where the opening between the sidewalls is widest. Flip the upper part of the device forward so the device goes flat into the holder. Slide the device straight downward into the holder. Press the block with the spring stud locking downward onto the upper part of the holder so it snaps into place.  
   
3. To remove the device from the holder: Press the block upward away from the holder. Press the device straight upward so the lower part reaches the widest part of the opening between the sidewalls. Flip the upper part of the device away from the holder and lift the device out from the holder.  
   
4. The holder is in place.

Related Products