Log in...

Passive holder with tilt swivel

Keep your unit in a passive holder and you will always have it within easy sight and reach! Neat, discreet and convenient. Custom made with a perfect, firm fit. You have full access to all buttons and outlets when the device is in the holder. You can connect a charging cable to the device when it is in the holder.

 

The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing, or switch between portrait and landscape mode. Tilts 17° and swivels 360°. Mounting plate 42x50 mm with AMPS-holes. Made of high grade black ABS/Acetal plastic. Made in Sweden. Attach onto ProClip Mounting Platform.

  • Item no: 711044
  • EAN: 7320287110449

Item no 711044 fits:

  • Ingenico iSMP4 (For all countries)
INSTALLATION INSTRUCTIONS:

1.

2.

3.

4.

Please read all of the instructions and look at the pictures before attaching the holder.  
 
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.  
 
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.  
 
3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.  
 
4. The holder is in place.

Attach your holder onto a ProClip!

You need two parts; a ProClip for your car, and a holder for your device. Find the correct ProClip for your vehicle here: