Log in...

Active holder with cig-plug

With tilt swivel. Fits for devices with skin; adjustable top.

Keep your phone's battery fully charged in an active holder, always within easy sight and reach! Neat, discreet and convenient. Fits device with skin. The top part of the holder is adjustable and adapts to the height of your phone. With cig-plug cable, 2A charging via the Micro-USB connector. You can charge a second device via the USB A outlet in the cig-plug, 1A charging. You have full access to all buttons when the device is in the holder. It is easy to slide the phone in place in the holder so it connects to the charging, and to take it out of the holder when leaving the vehicle. 
The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing, or switch between portrait and landscape mode. Tilts 17° and swivels 360°. Mounting plate 42x50 mm AMPS-holes. Made in Sweden. Attach onto ProClip Mounting Platform.


This product does not support OnePlus Dash charge, (quick charge).

Charging specification:

Cable length (+plug 58 cm): stretched:80 cm (or a bit more if needed).

  • Item no: 712076
  • EAN: 7320287120769

  • Width: 58 mm
  • Height: 180 mm
  • Depth: 49 mm
  • Volume: 512 cm³
  • Weight: 187 g

Item no 712076 fits:

  • OnePlus 6 (For all countries)
  • OnePlus 6T (For all countries)
  • OnePlus 7 (For all countries)





Please read all of the instructions and  look at the pictures before attaching the holder.
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.
2. To place the device in the holder: Place the upper part of the device in the holder, then press the device forwards and upwards so it snaps into place in the holder.

3. To remove the device from the holder: Press upwards on the lower part of the device, in the same time pull the the device out and down from the holder.
4. The holder is in place.

Attach your holder onto a ProClip!

You need two parts; a ProClip for your car, and a holder for your device. Find the correct ProClip for your vehicle here: