Log in...

Active holder with cig-plug

With USB-cable + cig-plug adapter with 2 USB ports: QC 3.0A + 2.4A. With tilt swivel. 12/24 Volt. Fits devices with skin that has the following dimensions: Height: 150-165 mm, Width: 88 mm, Thickness: 2-11 mm.

Keep your phone's battery fully charged in an active holder, always within easy sight and reach! Neat, discreet and convenient. Custom made with a perfect, firm fit. With USB-cable with cig-plug adapter, choose to connect either to the vehicle's USB outlet or the 12/24V socket. The cig-plug adapter has two USB ports: QC 3.0A + 2.4A. You have full access to the camera and all buttons when the device is in the holder. It is easy to slide the device into place in the holder so it connects to the charging, and to take it out of the holder when leaving the car.

 

The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing, or switch between portrait and landscape mode. Tilts 17° and swivels 360°. Mounting plate 42x50 mm with 4 mm AMPS-holes. Made of high grade black ABS/Acetal plastic. Made in Sweden. Attach onto a ProClip mounting platform.

 

Fits devices with skin that has the following dimensions: Height: 150-165 mm, Width: 88 mm, Thickness: 2-11 mm. (May fit for skins thicker than 11 mm, depending on shape/design of the edges).

 

Important note!

In order to be able to transmit audio files from your device through the USB-cable, this feature must be supported by the stereo in your car. You can easily test if this works by connecting your device to the stereo with the USB/charging cable that comes with your device. Charging through USB works regardless.

  • Item no: 721091
  • EAN: 7320287210910

  • Width: 93 mm
  • Height: 170 mm
  • Depth: 50 mm
  • Volume: 791 cm³
  • Weight: 206 g

Item no 721091 fits:

  • Apple iPhone 11 (For all countries)
  • Apple iPhone 12 (For all countries)
  • Apple iPhone 12 Pro (For all countries)
  • Apple iPhone XR (For all countries)
INSTALLATION INSTRUCTIONS:

1.

2.

3.

4.

Please read all of the instructions and  look at the pictures before attaching the holder.  
   
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.  
   
2. To place the device in the holder: Place the upper part of the device in the holder, then press the device forwards and upwards so it snaps into place in the holder.  
 
3. To remove the device from the holder: Press upwards on the lower part of the device, in the same time pull the the device out and down from the holder.  
   
4. The holder is in place.

Attach your holder onto a ProClip!

You need two parts; a ProClip for your car, and a holder for your device. Find the correct ProClip for your vehicle here: