Log in...

Active holder with cig-plug

With USB-A cable + cig-plug adapter with 2 USB-A ports: QC 3.0A + 2.4A. With tilt swivel. 12/24 Volt.

This holder is the perfect choice when you want to have your device installed in place as well as charging for it. Safe, efficient and convenient! With USB-A cable with cig-plug adapter, connect either to the vehicle's USB-A outlet, or the 12/24V socket. The cig-plug adapter has two USB-A ports: QC 3.0A + 2.4A. You have full access to the camera, buttons and ports while in use. Easy one-hand insertion and removal.

 

The holder is customized with a perfect fit for bare devices (not for case). With tilt swivel, you can easily adjust the angle for better viewing. Tilts 17° and swivels 360°. Attach the holder onto any flat surface, mount or Pedestal Mount in any vehicle, table top or other location. Mounting plate 42x50 mm with 4 mm AMPS-holes. Made of high grade ABS/Acetal plastic. Color: Black. Made in Sweden.

 

Choose installation placement with care, devices must not be placed in positions where they may block the view or important controls. The cradle should only be attached onto a suitable place. Installations always take place at the customer's own discretion and responsibility.  

  • Item no: 721271
  • EAN: 7320287212716

  • Width: 220 mm
  • Height: 174 mm
  • Depth: 44 mm
  • Volume: 1684 cm³
  • Weight: 337 g

Item no 721271 fits:

  • Lenovo Tab K10 TB-X6C6F (For all countries)
INSTALLATION INSTRUCTIONS:

1.

2.

3.

4.

Please read all of the instructions and  look at the pictures before attaching the holder.
 
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.

2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.
 
3. To place the device in the holder: Slide the device sideways into the holder until you hear / feel it snaps into place. To remove the device from the holder: Slide the device sideways and out.
 
4. The holder is in place.

Attach your holder onto a ProClip!

You need two parts; a ProClip for your car, and a holder for your device. Find the correct ProClip for your vehicle here: