Log in...

Mount

Rail mount for OtterBox uniVERSE case. Active mount for fixed installation. With tilt swivel. 12/24 Volt.

Keep your phone's battery fully charged in an active holder, always within easy sight and reach! Neat, discreet and convenient. Custom made with a perfect, firm fit for OtterBox uniVERSE case. Simply snap/slide your phone into place on the rail mount for easy attachment and charging connection. For fixed installation. The holder is to be connected inside the dashboard, providing an elegant installation without any cables hanging over the interior. The charging box has two USB ports: QC 3.0A + 2.4A. You have full access to the camera and all buttons when the device is in the holder.

 

The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing, or switch between portrait and landscape mode. Tilts 17° and swivels 360°. Mounting plate 42x50 mm with 4 mm AMPS-holes. Made of high grade black ABS/Acetal plastic. Made in Sweden. Color: black. Connect the power cable with a 2A fuse. Professional installation recommended. Attach onto a ProClip mounting platform.

Charging specification:

- Input Molex 2-Pin

- Output Connector Type: Dual USB Type-A Female.

- Output Voltage: 5V, 9V, 12V(Nominal)

- Output Current:
- USB Port 1: 3.6V ~ 6V/3A 6.2-9V/2A 9.2-12V/1.5A (Recommended for Android etc)
- USB Port 2: 4.9V ~ 5.25V 2.4A (Recommended for Apple)
- Output Voltage Ripple: 300mV pk-pk at Max Load

- Input Voltage Range: DC 12--24V DC, Input can handle 40V Load dump translent events

- Input Current: 3.0 A DC Max

- Input Current with No device attached: 0.005A

- DC-DC Conversion Efficiency: Over 86% Typical

- Rated Power:

- USB Port 1: 18 Watts Max.

- USB Port 2: 12 Watts Max.

 

  • Item no: 727219
  • EAN: 7320287272192

  • Width: 53 mm
  • Height: 110 mm
  • Depth: 48 mm
  • Volume: 280 cm³
  • Weight: 238 g

Item no 727219 fits:

  • Samsung Galaxy S10 (For all countries)
  • Samsung Galaxy S10e (For all countries)
INSTALLATION INSTRUCTIONS:

1.

2.

3.

4.

Please read all of the instructions and look at the pictures before attaching the mount.  
 
1. Loosen the screw in the center of the mount so you can remove the tilt swivel attaching plate on the back.  
 
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.  
 
3. Place the mount over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.  
 
4. The mount is in place.