Log in...

Holder with lock.

Active for fixed installation. With easy-switch system and tilt swivel. With USB Host. Fits for devices with OtterBox uniVERSE case.  2 keys included.

This holder is the perfect choice when you want to have your device securely locked in place and still easy accessible. Custom fit for device with OtterBox uniVERSE case. The holder has an extra robust design for an extra secure fit and is equipped with a lock. In order to remove the device from the holder you need a key (two keys are included). With USBG host port.


The active holder for fixed installation is to be connected inside the dashboard. It provides a discreet and neat installation without any cables hanging over the interior. Safe and convenient! The holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position.Tilts 17° and swivels 360°. It is easy to put the device into place in the holder, and to take it with you when leaving the car. Mountingplate 42x50 mm with 4 mm AMPS-holes. Made of high grade black ABS/Acetal plastic. Color: black. Made in Sweden. The product is E-approved. Connect the power cable with a 2 A fuse. Professional installation recommended. 12/24 Volt. Attach the holder to any flat surface or a Pedestal Mount in a truck, distribution vehicle, warehouse etc.


Easy-switching system:

The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds.

  • Item no: 736208
  • EAN: 7320287362084

  • Width: 229 mm
  • Height: 207 mm
  • Depth: 60 mm
  • Volume: 2844 cm³
  • Weight: 707 g

Item no 736208 fits:

  • Samsung Galaxy Tab Active 2 SM-T390/SM-T395 (For all countries)





Please read all of the instructions and look at the pictures before attaching the holder.

1. To attach USB cable to the holder: Attach the USB cable to the connector. Place the attaching part over the cable and screw it into place with the enclosed screws and tool.

2. To attach the holder: Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

3. To place the device in the holder: Place the lower part of the device in the holder. Flip/press the upper part of the device forwards so it snaps into place in the holder. Press the lock downward. Press the button to lock.
To remove the device from the holder: Use the enclosed key to open the lock. Slide the lock upward. Flip/pull the upper part of the device out from the holder, then lift the device up and out from the holder.

4. The holder is in place.