Log in...

Holder with Pass-Through Connector

Adjustable holder, fits devices with skins.

Holder with pass-through connector. This means that all cables that can be used with the iPhone can also be used with the holder, for example a charging cable or an interface cable. When you have attached the cable to the holder it is firmly in place and you do not have connect it manually to the device each time you put the iPhone in the holder. (Cable not included)

 

You can easily take the device with you when leaving the vehicle. The holder is equipped with a tilt swivel so it can be adjusted in order to avoid light reflection on the screen. Attach onto ProClip Mounting Platform.

  • Item no: 915290
  • EAN: 7320289152904



Product sheets: 233452.pdf

Item no 915290 fits:

  • Apple iPhone 2G (For all countries)
  • Apple iPhone 3G (For all countries)
  • Apple iPhone 3GS (For all countries)
INSTALLATION INSTRUCTIONS:

1.

2.

3.

4.

Please read all of the instructions and look at the pictures before attaching the holder.  
 
1. To adjust the holder to your unit: Loosen the screws on the back side of the holder, so the sides of the holders can be adjusted.  
 
2. Place the unit in the holder and press the sides together so the unit is firmly in place. Screw on the screws on the back side of the holder.  
 
3. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.  
 
4. The holder is in place.

Related Products