Log in...

Active holder with cig-plug

With tilt swivel. With USB cable. Fits for devices with skin.

The active holder charges your phone when it is in the holder. If you have a car with USB interface, you can disconnect the cig-plug from the holder's cable in order to get a USB-cable to connect directly to the USB connector in your vehicle.


The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection. Connects to the vehicle’s cigarette lighter socket, 12 Volt. Fits for devices with skin. Attach onto a ProClip Mounting Platform.


Important note!

In order to be able to transmit audio files from your device through the USB-cable this feature must be supported by the stereo in your car. This is easily tested by connecting your device to the stereo with the USB/charging cable that comes with your device. Charging through USB works regardless.


This product supports Qualcomm QC 2.0 quick charge (provided the device supports Qualcomm QC 2.0 quick charge).

  • Item no: 521409
  • EAN: 7320285214095

Item no 521409 fits:

  • Samsung Galaxy S III (AT&T SGH-i747) (For USA)
  • Samsung Galaxy S III (T-Mobile USA SGH-T999) (For USA)
  • Samsung Galaxy S III (Verizon SCH-i535) (For USA)
  • Samsung Galaxy S III i9300 (For Europe)
  • Samsung Galaxy S III i9305 (For all countries)
  • Samsung Galaxy S4 GT-I9505 (For all countries)
  • Samsung Galaxy S4 GT-I9506 (For all countries)





Please read all of the instructions and look at the pictures before attaching the holder.

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.

2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

3. To place the device in the holder: Place the upper part of the device in the holder, then press the device forwards and upwards so it snaps into place in the holder. To remove the device from the holder: Press upwards on the lower part of the device, in the same time pull the the device out and down from the holder.

4. The holder is in place.

Related Products

Attach your holder onto a ProClip!

You need two parts; a ProClip for your car, and a holder for your device. Find the correct ProClip for your vehicle here: