513137

Active holder for fixed installation

With tilt swivel, with Molex adapter system. 2A charger.

An active holder which is to be connected inside the dashboard, this gives a discreet, neat installation without cables hanging over the interior! The device has got the connector for charging on the top of the device. The active holders offer a firm fit, it is easy to put the device in the holder and then connect the charging cable to it.  
   
You can choose to use the holder as an active holder for charging of your device only, or to connect an adapter to the Molex connector for additional features. Then you can use the holder also for power supply of a GPS receiver or other own solutions (can not be used for data communication or audio connection).  
   
12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger.  Professional installation recommended. The holder is attached onto a tilt swivel so you can easily adjust your device in order to avoid light reflection. Attach onto a ProClip Mounting Platform.  
   
Charging specifications:  
Input voltage: DC/10-30V  
Charging voltage: DC/4.75-5.3V  
Output current(Typ): 2.0A  
Input & output protection: Input polarity reversal/Output over voltage/Output over current/Output short protection  
LED charging indicator: Power input indicator(Green), Ovp/Ocp/Output short(Red)  
Operating temperature: 0°C ~ +40°C  
Storage temperature: -20°C ~ +80°C  
RoHS compliant: ROHS

Item no 513137

EAN: 7320285131378



Item no 513137 fits:

  • Sony Ericsson Xperia X10 (For all countries)
INSTALLATION INSTRUCTIONS:

1.

2.

3.

4.

Please read all of the instructions and  look at the pictures before attaching the holder.  
   
1. Attaching the holder. Attaching the holder: Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.  
   
2. Place the attaching plate on desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the tilt swivel fits. Screw the holder onto the attaching plate. The holder is in place.  
   
3. Placing the device in the holder: Place the device upper part of the device into the lower part of the holder. Press the upper part of the device upwards into the holder. Carefully, slide the device up into the holder so you hear/feel it snaps into place.  
   
4. The holder is in place.

Attach your holder onto a ProClip!

You need two parts; a ProClip for your car, and a holder for your device. Find the correct ProClip for your vehicle here: