Active holder for fixed installation

With Molex adapter system. 2A charger. With tilt swivel.

Keep your phone's battery fully charged in an active holder, always within easy sight and reach! Neat, discreet and convenient. Custom made with a perfect, firm fit. For fixed installation. The holder is to be connected inside the dashboard, providing an elegant installation without any cables hanging over the interior. You have full access to the camera and all buttons when the device is in the holder. It is easy to slide the phone in place in the holder so it connects to the charging, and to take it out of the holder when leaving the vehicle. Fits only devices without the included back cover on.  
The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing, or switch between portrait and landscape mode. Tilts 20° and swivels 360°. Mounting plate 42x50 mm with predrilled AMPS-holes +2x3,5 mm centered holes. Made of high grade black ABS/Acetal plastic. Made in Sweden. Connect the power cable with a 2A fuse. Professional installation recommended. Attach onto ProClip Mounting Platform.  
Dimensions: 79 x 102 x 50 mm (W x H x D mm)  
Weight: 198 g  
Cable length: Total length: 241 cm (Holder to box: 70 cm, Connectors+box 14 cm, Box to open end: 157 cm.)  
Charging specifications:  
Input voltage: DC/10-30V  
Charging voltage: DC/4.75-5.3V  
Output current(Typ): 2.0A  
Input & output protection: Input polarity reversal/Output over voltage/Output over current/Output short protection  
LED charging indicator: Power input indicator(Green), Ovp/Ocp/Output short(Red)  
Operating temperature: 0°C ~ +40°C  
Storage temperature: -20°C ~ +80°C  
Approvals: E, CE, FCC, ROHS.

Item no 513958

EAN: 7320285139589

Item no 513958 fits:

  • Samsung Galaxy Xcover 4 (For all countries)





Please read all of the instructions and  look at the pictures before attaching the holder.  
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.  
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.  
3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel and screw it into place. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.  
4. The holder is in place.

Attach your holder onto a ProClip!

You need two parts; a ProClip for your car, and a holder for your device. Find the correct ProClip for your vehicle here: