530391

Active holder with cig-plug

Slim design with charger integrated in the holder. For use with Li-Ion or Li-Poly batteries.

Are you using a two-way radio every day in your work? Then a Brodit active holder will make your days much easier! By keeping the device in an active holder, you will always have it within easy sight and reach while driving between jobs. Not only that; the holder also supplies a fully charged battery at all times.  
 
The active holder has a unique slim design with the charging box integrated in the holder and LED indicator to show that charging is in progress, the indicator changes from red to green when fully charged. Attach onto a ProClip Mounting Platform.

Item no 530391

EAN: 7320285303911



Item no 530391 fits:

  • Motorola MTP 850 (For all countries)
INSTALLATION INSTRUCTIONS:

1.

2.

3.

4.

Please read all of the instructions and look at the pictures before attaching the holder.  
 
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.  
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.  
3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw firm at first, then loosen it a bit so the holder is firmly in place, but still can be adjusted.  
4. The holder is in place.  
 
Specifications:  
Input voltage 11-30 Volt  
Output voltage 4.6 Volt  
Charge current 1.6A  
Charge time 2-3 hours  
Efficiency 82%  
Built-in 2,5A non replaceable fuse

Attach your holder onto a ProClip!

You need two parts; a ProClip for your car, and a holder for your device. Find the correct ProClip for your vehicle here: