The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.

Item no 852836 - Angled mount

EAN: 7320288528366

Item no 852836 fits:

  • Seat Alhambra 01-10 (For Europe)
  • Volkswagen Sharan 01-10 (For Europe)





Attention! Read all instructions before attaching the ProClip.
This ProClip consists of two parts.
Part 1. Attaching piece.
Part 2. ProClip face plate.

1. Press the angled edge of Part 1 into the gap between the dashboard and the frame surrounding the control panel. Press Part 1 away from the steering wheel, so th angled edge of Part 1 hooks under/behind the console frame.

2. Adjust Part 1 upwards in the gap so the upper part of Part 1 is 2,5 cm (1 inch) below the upper edge of the frame surrounding the control panel.

3. Press a screwdriver through the holes in the faceplate on Part 2 to open them up. Peel off both adheisve tape covers on Part 2. Place Part 2 onto Part 1 so the holes match. Screw the enclosed screws into the holes in Part 2.

4. The ProClip is in place.

Attach a holder onto your ProClip!

You need two parts; a ProClip for your car, and a holder for your device. Find the correct holder for your device here: